Poulan Pro PPB200E Manual do Utilizador descarregar pdf (Página 8)

4. CYLINDER ASSEMBLY - CONTINUED

SPARK PLUG

CYLINDER

CRANKSHAFT &

PISTON ASSY.

ALIGNMENT

PLATE

CRANKCASE CAP

TINNERMAN NUT

GROUND STRAP

HEAT SHIELD

“U” CLIP

FIGURE F FIGURE G

F. OIL RING AND INSTALL CRANKSHAFT, PISTON, AND ROD ASSEMBLY IN

CYLINDER (FIGURE F).

G. APPLY SMALL CONSISTENT BEAD OF SEALANT. BEAD MUST NOT BE "PUDDLED" OR

ANY SKIPS. NO PART OF SEALING BEAD IS ALLOWED IN BEARING POCKETS.

DO NOT LET SEALANT DRY OVER 5 MINUTES. (PRIOR TO ASSY.

H. POSITION GROUND STRAP TO CHASSIS (FIGURE F).

I. INSTALL THREE (3) TINNERMAN NUTS INTO CHASSIS POCKETS.

J. INSTALL HEATSHIELD AS SHOWN. "U" CLIP IS USED TO SECURE HEAT SHIELD

IN POSITION (LOW EMISSION ENGINES ONLY) (FIGURE F)..

K. PLACE CRANKSHAFT ALIGNMENT PLATE INTO LOCATING HOLES ON CHASSIS.

PLACE CHASSIS ON CYLINDER, ALIGNING CRANKSHAFT WITH PLATE.

L. SECURE CYL. TO CHASSIS. TORQUE TO 100 IN/LB MIN.

www.mymowerparts.com

For Discount Poulan Poulan Pro Parts Call 606-678-9623 or 606-561-4983

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Sem comentários

Poulan Pro PPB200E Manual do Utilizador Página 8