Poulan Pro PPB200E Manual do Utilizador descarregar pdf (Página 5)

1. CRANKSHAFT, PISTON, AND ROD ASSEMBLY

A. CARE MUST BE TAKEN TO PROTECT SURFACE OF PISTON FROM NICKS AND

SCRAPES.

B. PISTON PIN ASSEMBLY FIXTURE MUST BE KEPT CLEAN TO AVOID DAMAGE TO

THE PISTON.

C. PISTON PINS MUST BE CLEAN AND FREE OF NICKS AND SCRATCHES. (DO NOT

THROW OR SUBJECT TO SEVERE JOLTS DURING HANDLING.)

D. CONNECTING ROD SHOULD REVOLVE FREELY AROUND CRANK PIN.

E. PLACE A DROP OF POULAN 2-CYCLE ENGINE OIL ON CRANK PIN BEARING AND

ON PISTON PIN BEARING AS SHOWN.

IMPORTANT NOTE: USE SEAL PROTECTOR WHEN INSTALLING BEARING AND

SEAL ASSEMBLY ONTO SHAFT.

F. INSTALL BEARING AND SEAL ASSEMBLY ONTO CRANKSHAFT.

NOTE: BEFORE INSTALLING SEALS, APPLY POULAN 2 -CYCLE ENGINE OIL AS

SHOWN IN FIGURE B.

G. INSTALL OILER WORM GEAR ONTO CRANKSHAFT WITH ASSEMBLY TOOL UNTIL

COIL FALLS IN GROOVE. MAINTAIN COIL PITCH 2.59 - 2.92MM. (FIGURE C)

NOTE; WORM GEAR INSTALLATION IS CRITICAL. USE

TOOL PN 530031166 FOR CORRECT PITCH SPACING.

(FIGURE C)

www.mymowerparts.com

For Discount Poulan Poulan Pro Parts Call 606-678-9623 or 606-561-4983

1 2 3 4 5 6 7 8 9 10 ... 30 31

Sem comentários

Poulan Pro PPB200E Manual do Utilizador Página 5